BMW & MINI ELV Steering lock emulator & RESET kit. THE REAL plug & play solution

BMW & MINI ELV Steering wheel LOCK Emulator for CAS, Repair FIX Malfunction error. DESPITE ITEM DESCRIPTIONS THIS IS THE ONLY PLUG & PLAY PACK IN THE MARKET! EQUIPPED WITH PERFECT FIT PLUG, ONLY PLUGS IN ONE WAY! As you can read (or not) in other emulators description, in some cases an ELV error counter reset is REQUIRED in CAS module. If you haven't knlowledge, cables and special tools you won't be able to carry out the reset procedure. This tool eliminates the need of that thigs. IT WORKS EVEN IF YOUR CAR ALREADY STUCKED AND ENGINE START IS NOT POSSIBLE! Before installation of the emulator, just connect this tool to OBD port of your BMW and it will carry out the whole ELV counter reset procedure without need to push any buttons etc.

The SPEEDOMETER will display the progress. It will move from 0-60 or 0-100 then back to zero.

At the same time, the resetter will blink green 3 times. After this you can unlock steering, connect the emulator, and start the car again. Should be noted that you can use this resetter tool for only one car unlimited times. It locks itself to VIN number at the first use. So don't try it on other car before use because you cannot use it for your car in this case. (it will lock itself to the other car) Offered item is a BUNDLE product with ELV emulator for the BMW E-series and also for Mini R55, R56 with electric steering lock. The emulator simulates a perfectly working ELV for the CAS. Thus, no more check control message and the BMW starts again. For CAS2, CAS3, CAS3+ Supported models: E70, E71, E72, E81, E82, E83, E84, E87, E88, E90, E91, E92, E93, E60, E61, E63, E64 and Mini R55, R56, 1 3 5 6 X1 X3 X5 This is the newest version!

Advantages against other ELV emulators. Only plugs in one way. This eliminates the guesswork about pin connection. EQUIPPED WITH PERFECT FIT PLUG TYPE!

-Protective plastic case included, which protects item from short circuit, dust, condenstaion, mechanical damage. Longer connector cable which provides easier placement and installation. Compatible with 3 and 4 pin ELV modules too.

If the steering wheel lock on your BMW is mechanically faulty, the emulator can solve the problem cost effectively. Ignoring the fault will lead to steering locking you out and resulting in a non-start of your car. Of course, BMW Workshop wants to replace the complete steering column in this case. The problem with ELV is known in the E81, E82, E87, E88, E90, E91, E92, E93, E60, E61, E63 and E64 models and also Mini R55, R56. Works also with the 1er and 3er BMW which only 3 cables at the ELV has.

Installation procedure is simple: Remove trim panel under steering column (3 screws). Disconnect the 3 or 4 pin plug from your ELV unit. That is located approximately in the middle of the steering column. If exists, Pin 4 is only a high current power line which powers the ELV module mechanical parts.

This is not used by the emulator, since it does not contains any mechanical parts. So don't worry, this emulator will be good for 3 and 4 pin ELV modules too. Plug the car connector onto the emulator and start the car.

After installation of ELV emulator, the vehicle has no more errors and starts normally. Check if the message has disappeared. It wont fix your problem if you have a faulty CAS unit and/or the cable or plug is damaged or broken which leads from CAS to ELV unit!

This item is in the category "Vehicle Parts & Accessories\Car Parts & Accessories\Steering & Suspension\Steering Columns". The seller is "elv-emulators" and is located in this country: GB. This item can be shipped worldwide.

Brand: BMW
Type: Steering Column
Manufacturer Part Number: BMW-MINI-ELV
Country/Region of Manufacture: United Kingdom