We are pleased to announce that we now have the full compliment of switch housings ready to dispatch. With the correct factory spec logo as per the pictures, a real easy DIY job to swap your internals, see below. A very limited run of parts as requested by you our customers. You are looking at a set of MK1 Escort Switch Outer Housings with Printed Rocker.
Head Light housing - remanufactured with the correct curved housing. Heater / Fan switch - remanufactured twin position switch.
Wiper switch - remanufactured twin position or single position switch housing. Heated rear window switch - remanufactured with the correct housing and with the. Remanufactured with the correct housing and with the red. We can for a small charge swap your internals for you, or just follow our simple. The decal is as per the Ford original items being directly printed, not a sticker and these are all new parts.Not re chromed outer housings and polished rockers. Its as easy as one, two, three and you no longer need to send your switches away. Get your tools out, you'll need the following. Wire wool to clean your connectors. Small electrical screw driver to remove the back electrical connector. Once your old switch has been removed from your loom, lay both switches out on the table ready to swap components, like below. Lay your old switch out on the table and applying lite pressure from behind the connectors taking care not to damage the black connector. Separate the connector from the switch housing taking care as there is a spring built into the yellow or white block slider block.
Now lay all of your components out on the table so you know how they go back, pay attention to the position of the slot on the little yellow spring connector pic 2 as the slot aligns with the. Black rocker in pic 3 below. Now take some time cleaning the electrical connectors so they look like this - wire wool is superb for this, ensure you do both sides to finish the job. Also take time to clean the side spring clips prior to refitting. Re-assemble the switch in reverse order so it looks like this with the side retaining clips in place.Refit the switch back onto your loom. Switch housing kits can be bought as a kit or individually as priced above. This item is in the category "Vehicle Parts & Accessories\Car Parts & Accessories\Interior Parts & Accessories\Switches & Controls".
The seller is "classic-trim" and is located in this country: GB. This item can be shipped to North, South, or Latin America, all countries in Europe, all countries in continental Asia, Australia, New Zealand, Egypt, Reunion, South Africa.